How to clean the dust of the laser cutting dust purifier?

Laser smoke filter systems are important for maintaining a safe and productive workplace.But the ash on the top of laser dust removal is a big risk in work shop. In this article, you will learn the reasons and the solutions of dust collector laser.   

When you find there are ash on the laser cutting dust purifier , there may be three reasons:

1. The filter cartridge is not installed correctly;

2. The use of the filter cartridge is too long;

3. The degumming of internal sealing.

The solution to the ash phenomenon is as follows:

Firstly, please check that the cartridge is properly installed. Ensure that the cartridge is tightly connected to the purifier. If any problem is found, re-tighten the cartridge fixing screws.

Secondly, please repleace a new filter cartridge when cartridge is damaged. Regular inspection of the condition of the filter cartridge, and timely replacement according to the use of conditions, can ensure the continuous and good purification effect.

Finally, you should checked there are no problems such as degumming or leakage in the fume extractor laser. If it is found that there is a sealing problem around the purification chamber, it is necessary to re-construct the sealant to ensure effective sealing performance.

If there is still ash after the above checks, contact experts immediately for help. They have the knowledge and experience in the relevant field to examine and diagnose problems in depth and provide appropriate solutions.